DeWalt DCS375 - Maintenance

11
ENGLISH
Repairs
The charger and battery pack are notserviceable. There are
no serviceable parts inside the charger or batterypack.

WARNING: To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment (including brush
inspection and replacement, when applicable) should
be performed by a DeWALT factory service center or a
DeWALT authorized service center. Always use identical
replacementparts.
Accessories

WARNING: Since accessories, other than those offered
by DeWALT, have not been tested with this product, use
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only DeWALT recommended
accessories should be used with thisproduct.
Recommended accessories for use with your tool are available
at extra cost from your local dealer or authorized service
center. If you need assistance in locating any accessory, please
contact DeWALT call 1-800-4-DeWALT (1-800-433-9258) or
visit our website: www.dewalt.com.
Cleaning

WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the risk
of eye injury, always wear ANSI Z87.1approved eye
protection when performingthisprocedure.

WARNING: Never use solvents or other harsh
chemicals for cleaning the non‑metallic parts of the
tool. These chemicals may weaken the plastic materials
used in these parts. Use a cloth dampened only with
water and mild soap. Never let any liquid get inside the
tool; never immerse any part of the tool into aliquid.
YES
YES
NO
Recommended Cutting Positions
YES
NO
2. Bring the work stop
5
into contact with the workpiece
while keeping the blade off of the workpiece. Turn the
sawon.
3. When saw reaches desired rotation speed, slowly and
gently tilt the main body of the tool to bring the band
saw blade into contact with the workpiece. Do not apply
additional pressure in excess of the weight of the main
body of the tool. Carefully avoid bringing the band saw
blade suddenly and heavily into contact with the upper
surface of the workpiece. This will cause serious damage
to the band saw blade. To obtain maximum service life of
the band saw blade, ensure there is no sudden impact at
the beginning of the cuttingoperation.
4. Straight cutting can be accomplished by keeping the
band saw blade aligned perpendicular to the material.
Any twisting or cocking of the blade will cause the cut to
go offline and decrease the life of theblade.
NOTICE: During cutting, if the band saw becomes
locked or jammed in the workpiece material, release
the switch immediately to avoid damage to the band
saw blade andmotor.
5. The tool’s own weight provides the most efficient
downward cutting pressure. Added operator pressure
slows the blade and reduces bladelife.
6. End pieces, which would be heavy enough to cause
injury when they drop, after cut-off, should be supported.
Safety shoes are strongly recommended. End pieces may
be hot andsharp.
MAINTENANCE

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start‑up can causeinjury.
Tips for Better Cutting
The following recommendations should be used as a guide
(refer to Recommended Cutting Positions). Results may vary
with the operator and the particular material beingcut.
• Never twist the band saw blade during cuttingoperation.
• Never use liquid coolants with portable band saws.
Use of liquid coolants will cause build-up on tires and
reduceperformance.
• If excessive vibration occurs during the cut, ensure that
the material being cut is is securely clamped down. If
vibration continues, change the band sawblade.
• Always keep at least 2–3 teeth engaged in thecut.
Lubrication
Self-lubricating bearings are used in the tool and periodic
relubrication is not required. In the unlikely event that
service is ever needed, take your tool to an authorized
servicelocation.