ENGLISH
7
2. For long storage, it is recommended to store a fully
charged battery pack in a cool dry place out of the
charger for optimal results.
NOTE: Battery packs should not be stored completely
depleted of charge. The battery pack will need to be
recharged before use.
SAVE THESE INSTRUCTIONS FOR
FUTURE USE
COMPONENTS (FIG. A)
WARNING: Never modify the power
tool or any part of it. Damage or personal injury
couldresult.
Refer to Figure A at the beginning of this manual for a
complete list ofcomponents.
Intended Use
This string trimmer is designed for professional trimming
applications. DO NOT use under wet conditions or in
presence of flammable liquids orgases.
This string trimmer is a professional appliance. DO NOT
let children come into contact with the tool. Supervision is
required when inexperienced operators use thisappliance.
This is not an edger and is not intended to be used foredging.
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of
serious personal injury, turn unit off and remove
the battery pack before making any adjustments
or removing/installing attachments or
accessories. An accidental start-up can causeinjury.
WARNING: Never remove the guard.
Damage or personal injury couldresult.
WARNING: NEVER OPERATE appliance
WITHOUT GUARD FIRMLY IN PLACE. The guard
must always be properly attached on the appliance to
protect theuser.
Assembling the Pole (FIG. A, C)
1. To assemble the pole, line up the hole
(
15
)
in the lower
trimmer pole
(
8
)
with the pin
(
16
)
on the pole bracket
(
9
)
.
2. Pull the pin out and slide the lower trimmer pole into
the upper trimmer pole
(
7
)
as shown in figureC.
3. Release the pin and ensure it fully engages the hole.
4. Secure the poles by tightening the bracket wingnut
(
17
)
.
fig. C
17
16
15
Adjusting the Auxiliary Handle (FIG. A, D)
If adjustment is necessary, loosen the handle bolts
(
19
)
and
slide the auxiliary handle up or down the upper trimmer
pole
(
7
)
. Then, retighten the bolts
(
19
)
through the bracket
(
18
)
. Ensure the handle is securely attached.
fig. D
18
1919
OPERATION
WARNING: To reduce the risk of
serious personal injury, turn unit off and remove
the battery pack before making any adjustments
or removing/installing attachments or
accessories. An accidental start-up can causeinjury.
WARNING: Always use proper eye
protection that conforms to ANSI Z87.1 (CAN/CSA
Z94.3) while operating thisappliance.
Installing and Removing the Battery Pack
(Fig. A, E, F)
NOTE: For best results, make sure your battery pack is
fullycharged.
WARNING: Before removing or
installing battery, make certain the lock-off lever is not
engaged to prevent trigger actuation.
To install battery pack: Insert battery pack
(
13
)
into battery
housing
(
12
)
as shown in figureE until fully seated and an
audible click is heard.
Make sure battery pack is fully seated and fully latched into
position.
To remove battery pack: Depress the battery release
button
(
14
)
on the battery and pull battery pack out of
appliance as shown in figureF.
fig. E
To Next Page
Loading...
Need help?
General
