14
ENGLISH
WARNING: To reduce the risk of serious personal
injury, turn dust extractor off and disconnect battery
pack before making any adjustments or removing/
installing attachments or accessories and if the
dust extractor head is removed from the tank or
not latched securely. An accidental start-up can
causeinjury.
The dust extractor must be handled for cleaning and
maintenance in a way, that avoids exposing maintenance
personnel and other persons to any hazards.
• Wear personal protective equipment.
• Use filtered forced ventilation.
• Clean the dust extractor. Refer to Cleaning.
• When maintenance or repairs are carried out, all
contaminated parts which cannot be satisfactorily
cleaned
must be packed in impermeable bags and disposed of in
compliance with the applicable disposal regulations.
• After maintenance or repairs clean the maintenance area in
a way that prevents hazardous substances escaping into the
surrounding environment.
The charger and battery pack are notserviceable.
Lubrication
Your dust extractor requires no additionallubrication.
Cleaning (Fig. A, I)
WARNING: Never use solvents or other harsh chemicals
for cleaning the non-metallic parts of the dust extractor.
These chemicals may weaken the materials used in these
parts. Use a cloth dampened only with water and mild
soap. Never let any liquid get inside the dust extractor;
never immerse any part of the dust extractor into aliquid.
For cleaning and maintenance in a way that avoids exposing
maintenance personnel and other persons to any hazards, wear
personal protective equipment. Clean the maintenance area in a
way that prevents hazardous substances from escaping into the
surroundingenvironment.
Do not use a spray system, pressure jet washer or running water
for cleaning.
1. Vacuum the outside of the dust extractor. For further
cleaning use a cloth dampened only with water and mild
soap ifnecessary.
2. After use dispose of cloth in an appropriatecontainer.
3. Empty tank according the the section Dust
ExtractorCleaning.
4. Inspect water sensor probes
25
during dust extractor
cleaning. Water sense probes may become contaminated
during operation. If contamination is present, clean water
sense probes thoroughly with damp cloth to remove any
visiblecontamination.
Storage (Fig. A)
CAUTION: The three position switch must be in OFF (0)
position to prevent unintentional being switched on by
Wireless ToolControl.
1. Empty the tank. Refer to Dust Extractor Cleaning
underOperation.
2. Clean the dust extractor inside andoutside.
3. Clean or replace filters, refer toFilters.
4. Store the suction hose with the hose clips
5
and the power
cord as shown in the illustration. Place the unit in a dry room
and secure it from unauthorizeduse.
NOTE: Plug hose inlet plug
9
into inlet to keep debris inside
canister when suction hose is removed. You can also attach
the ends of the hose together and lock together with the
twist-lockend.
Optional Accessories
WARNING: Since accessories, other than those offered
by
, have not been tested with this product,
use of such accessories with this dust extractor could
be hazardous. To reduce the risk of injury, only
recommended accessories should be used with
thisproduct.
Consult your dealer for further information on the
appropriateaccessories.
A replacement filter is available at extra cost at your local
servicecentre.
Dust Collector
In the vacuum mode, the appliance can also function as a dust
collector for power tool applications producing dust ordebris.
IMPORTANT! The DWV9000 dust extraction adaptor is
designed to work with Dust System Compatible
power tools. An additional adaptor will be needed with
non-compatible
tools.
Optional Accessories
• DCV5861 Replacement Filters (Contains 2 DC5151H filters)
• DWV9316 Anti-Static Hose
• DWV9000 Twist Lock connection
• DWV9110 29mm–35mm tapered rubber adaptor
• DWV9120 35mm–38mm stepped rubber adaptor
• DWV9130 35mm OD Adaptor
• DWV9150 35mm OD angle adaptor
• DWST17889 Cart
• DWST17888 Trolley
The filter bags provide a clean, easy and quick way to dispose of
the dustcollected.
Paper filter bags: The DCV9401 filter bags are designed to
capture many types of dust including drywall, concrete and
wood. These bags should be disposed of once the airflow
becomes restricted. DO NOT reusebags.
DCV9401 Disposable paper filter bag