DeWalt DW45RN User Manual

• Do not drive nails blindly into walls,
FIG. U
floors or other work areas. Fasteners
driven into live electrical wires, plumbing,
or other types of obstructions can result
in injury. (Fig.U)
• Stay alert, watch what you are
doing and use common sense
when operating a power tool. Do
not use tool while tired or under
the influence of drugs, alcohol, or
medication. A moment of inattention while operating power tools
may result in serious personal injury.
• DEPTH ADJUSTMENT: To reduce risk of serious injury
from accidental actuation when attempting to adjust depth,
ALWAYS:
• Disconnect air supply.
• Avoid contact with trigger during adjustments.
WARNING: Some dust created by power sanding, sawing,
grinding, drilling, and other construction activities contains chemicals
known to the State of California to cause cancer, birth defects or other
reproductive harm. Some examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry
products, and
• arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you
do this type of work. To reduce your exposure to these chemicals:
work in a well ventilated area, and work with approved safety
equipment, such as those dust masks that are specially designed to
filter out microscopic particles.
WARNING: ALWAYS USE SAFETY GLASSES. Everyday
eyeglasses are NOT safety glasses. Also use face or dust mask
if operation is dusty. ALWAYS WEAR CERTIFIED SAFETY
EQUIPMENT:
• ANSI Z87.1 eye protection (CAN/CSA/Z94.3),
• ANSI S12.6 (S3.19) hearing protection,
• NIOSH/OSHA/MSHA respiratory protection.
SAVE ALL WARNINGS AND INSTRUCTIONS
FOR FUTURE REFERENCE
Specifications
MODEL DW45RN
HEIGHT 9.8" (249mm)
WIDTH 5" (127 mm)
LENGTH 11" (280mm)
WEIGHT 5.2 lb (2.4 kg)
OPERATING PRESSURE 70 – 120 psig (4.9 – 8.43kg/cm
2
)
AIR CONSUMPTION
PER 100 CYCLES *
3.7 cfm @ 80 psi (5.62 kg/cm
2
)
LOADING CAPACITY 120 Nails
FASTENER 0.120" (3mm) diameter,
15º wire collated roofing nails
FASTENER LENGTHS 3/4" (19 mm) - 1-3/4" (44.5 mm)
AIR INLET 1/4" NPT (6.4mm)
NOTE: Use only D
e
WALT approved fasteners
English
5

DeWalt DW45RN Specifications

General

Brand	DeWalt
Model	DW45RN
Category	Power Tool
Language	English