DeWalt DW714 - Page 58

ENGLISH
56
(80–120 tooth carbide) blade and a slower for aluminum,
even cutting rate will produce the desired results.

WARNING: Ensure that the material does not creep
while cutting; clamp it securely in place. Always let
the blade come to a full stop before raising the arm.
If small fibres of wood still split out at the rear of the
workpiece, stick a piece of masking tape on the wood
where the cut will be made. Saw through the tape and
carefully remove tape whenfinished.
Clamping the Workpiece (Fig. C, AA, BB)
1. Whenever possible, clamp the wood/ aluminum to
thesaw.
2. For best results use the clamp
33
made for use with
your saw. Clamp the workpiece to the fence whenever
possible. You can clamp to either side of the saw blade;
remember to position your clamp against a solid, flat
surface of fence.
Mounting the clamp (Fig. AA):
1. Inserting the vertical clamp
33
into the holes
39
as
shown in FigureAA, then rotate to the right position.
If horizontal clamp is needed, insert the horizontal clamp
into holes
43
as shown in Figure BB.

WARNING: Always use a material clamp when
cutting non-ferrous metals.

WARNING: Always use both of vertical clamp and
horizontal clamp when cutting smallpieces.
39
Fig. AA
33
39
Fig. BB
43
43
43
43
Support for Long Pieces (Fig. C, CC)
1. Always support long pieces.
2. For best results, use the extension work support
35
to extend the table width of your saw. Support
long workpieces using any convenient means such
as saw-horses or similar devices to keep the ends
fromdropping.