DeWalt DW714 - Changing or Installing a New Saw Blade

ENGLISH
50
Fig. F
10
Changing or Installing a New Saw Blade
(Fig. G–J)

WARNING: To reduce the risk of serious personal
injury, turn off the tool and disconnect it from
the power source before attempting to move it,
change accessories or make any adjustments.

CAUTION:
• Never depress the spindle lock button while the
blade is under power or coasting.
• Do not cut ferrous metal (containing iron or steel)
or masonry or fiber cement product with this
miter saw.
• Depress the head lock up release lever
29
(if
equipped) to release the lower guard
2
,then raise
the lower guard as far as possible.
• Always choose the correct blade for material
being cut.
Fig. G
29
2
Removing the Blade (Fig. H–J)
1. Unplug the saw.
2. Raise the arm to the upper position and raise the lower
guard as far as possible.
3. Loosen, but do not remove guard bracket screw
37
until the bracket
38
can be raised far enough to
access the blade screw
40
(Fig. J). Lower guard will
remain raised due to the position of the guard bracket
screw
37
.
Fig. H
37
38
4. Depress the spindle lock button
24
while carefully
rotating the saw blade by hand until the lock engages.
5. Keeping the button depressed, use the other hand and
the wrench
9
provided to loosen the blade screw
40
.
(Turn clockwise, left-hand threads)
6. Remove the blade screw, outer clamp washer
42
, and
blade
41
. The inner clamp washer
44
, may be left on
the spindle.
Fig. I
24
40
9