Package Contents
The package contains:
1 Partly assembled machine
1 Rip fence
1 Mitre gauge
1 Saw blade
1 Upper blade guard assembly
1 Throat plate
2 Blade wrenches
1 Dust extraction adapter
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or accessories which may have occurred during transport.
• Take the time to thoroughly read and understand this manual prior to operation.
Description (fig. 2, 3)
Your DWE7491-XE jobsite table saw has been designed to perform the four main sawing operations of ripping,
cross-cutting, bevelling and mitring easily, accurately and safely in wood, wood products and plastics. This unit is
designed for use with a 254 mm carbide-tipped blade.
A. Table
B. Blade
C. Rip scale indicator
D. Fine adjust knob
E. Rail lock lever
F. Blade height adjustment wheel
G. Bevel lock lever
H. ON/OFF switch
I. Mounting holes
J. Miter gauge
K. Blade guard assembly
L. Blade guard release lever
M. Splitter
N. Dust exhaust port
O. Guard dust exhaust port
P. Throat plate
Q. Rip fence
R. Rip fence latch
S. Work support/narrrow rip fence (shown in stored
position)
T. Blade wrenches
U. Push stick (shown in stored position)
ELECTRICAL SAFETY
The electric motor has been designed for one voltage only. Always check that the power supply corresponds
to the voltage on the rating plate. 230 V AC means your tool will operate on alternating current. As little as 10%
lower voltage can cause loss of power and can result in overheating. All DEWALT tools are factory tested; if this
tool does not operate, check the power supply. Your DEWALT tool is double insulated, therefore no earth wire is
required.
• Young children and the infirm. This appliance is not intended for use by young children or infirm persons
without supervision. Young children should be supervised to ensure that they do not play with this appliance.
• Replacement of the supply cord. If the supply cord is damaged, it must be replaced by the manufacturer or
an authorised DEWALT Service Centre in order
to avoid a hazard.
Extension Cords
CAUTION: Use only extension cords that are approved by the country’s Electrical Authority. Before using exten-
sion cords, inspect them for loose or exposed wires, damaged insulation and defective fittings. Replace the cord if
necessary.
FIGURE 1
FIGURE 2
A
P
K
E
F
D
G
L
SS
S
Q
H
C
J
O
T
S
SS
R
I
U
B
N
M
4
To Next Page
Loading...
