DeWalt DWEHF1838K - Maintenance Checklist

-13-
MAINTENANCE CHECKLIST
Maintenance Benefit Procedure Service Interval
Inspect trigger performance Ensure trigger system is in
proper working order
Refer to Tool Operation Check
section in this manual
Daily
Drain condensation from air
compressor tanks and air filters
(if present)
Prevents accumlation of
moisture that can impede tool
performace
Open drain cock on tanks and air
filters and drain all condensate
Daily
Clean magazine assembly Prevents accumlation of debris
that could cause a jam
Blow clean with compressed air Daily
Clean nose assembly Prevents accumlation of debris
that could cause a jam
Blow clean with compressed air Daily
Ensure all fasteners remain tight Prevent loose parts Tighten all fasteners with
appropriately sized hex wrench
Weekly
Replace air fitting Maintains proper air flow to
engine for peak performance
Remove worn air fitting and
replace with new fitting
50,000 Fasteners
Replace piston/driver assembly Maintains consistent drive
quality
Refer to replacement part kit
instructions
150,000 Fasteners
Replace O-rings Maintains engine for peak
performance
Refer to replacement part kit
instructions
250,000 Fasteners
Replace bumper Maintains engine for peak
performance
Refer to replacement part kit
instructions
250,000 Fasteners
Replace headvalve Maintains engine for peak
performance
Refer to replacement part kit
instructions
250,000 Fasteners
Replace engine cylinder Maintains engine for peak
performance
Refer to replacement part kit
instructions
500,000 Fasteners