6
English
STRIP 2
VELCRO
5. Peel the backing off the mating Velcro piece and press firmly
onto the designated compressor location.
6. Be sure the Air Compressor Monitoring Device is securely
mounted to the compressor by firmly, but carefully, pushing
on the front of the device with your full hand.
7. Try pulling the device off of the compressor with a
moderate pull.
NOTICE: The device should not pull off without fairly
significant pull force.
8. After the test pull, give the device one more push to reconnect
any hook and loops that may have separated during
the test pull.
Pairing Device to Mobile Application
Download
Android IOS
Go to Google Play Store Go to App Store
Search for DEWALT Air Compressor Monitoring System
Install App
The Device works with the mobile application to provide a record
of air compressor hours ran so the APP can automatically remind
you when key maintenance activities need to be performed to
get the most useful life out of your investment. You will be able
to view both detailed and summary run times on your APP. Air
Compressor Monitoring Device must be paired to the application
to function properly.
During the set-up of your air compressor in the application, follow
these steps to connect the device:
1. Make sure (3) fully charged Size AA batteries are installed in
the device.
2. Make sure the Air Compressor Monitoring Device is securely
mounted to the compressor.
3. Make sure the application is installed on your phone.
4. In "Settings" on your phone, make sure the Bluetooth is "ON"
in order for the device to be discoverable.
To Next Page
Loading...
