P3600
EN
9
TOOL MALFUNCTION
1. In the event that a load fails to discharge after the trigger is pulled, the tool must be kept depressed
against the work surface for a minimum of 30 (thirty) seconds in case of a delayed load discharge. Then
carefully remove the entire load strip and store it in a can of water or other nonflammable liquid and
dispose in accordance with local jurisdiction and safety data sheet (SDS). Never attempt to force or pry a
load out of a tool chamber.
2. Never discard powder loads into a trash container or fire bin.
3. Do not attempt to unload or disassemble a jammed, stuck or broken tool as improper handling may
cause it to discharge and strike operator and/or bystander. A jammed tool must be pointed in a safe
direction at all times. Tag the tool and lock it up. Call your DEWALT representative for proper assistance.
To Next Page
Loading...
