WARNING
PRIOR TO OPERATING THE P3500 TOOL, STUDY THIS MANUAL CAREFULLY AND DEVELOP A THOROUGH
UNDERSTANDING OF THE CONTENTS.
PROPER TRAINING ACCORDING TO THE CURRENT ANSI STANDARD A 10.3, SAFETY REQUIREMENTS FOR
POWDER ACTUATED FASTENING SYSTEMS MUST BE COMPLETED AND A DEWALT QUALIFIED OPERATOR
CARD MUST BE OBTAINED PRIOR TO OPERATION OF THE TOOL. STATE, LOCAL, OR OTHER REGULATIONS
SHOULD ALSO BE FOLLOWED. LAWS, REGULATIONS, AND STANDARDS REGARDING THE USE OF POWDER
ACTUATED TOOLS MAY PERIODICALLY BE REVISED. ANY SUCH REVISIONS MAY CHANGE THE SAFETY AND
OPERATING PROCEDURES DESCRIBED IN THIS MANUAL. DEWALT, INC. IS NOT RESPONSIBLE FOR ANY
SUCH REVISIONS WHICH OCCUR AFTER PUBLICATION OF THIS MANUAL. IT IS THE RESPONSIBILITY OF THE
USER TO MAINTAIN FAMILIARITY WITH THE CURRENT LAWS, REGULATIONS, AND STANDARDS THAT APPLY
TO THE POWDER ACTUATED TOOL.
DANGER
TO AVOID SERIOUS INJURY OR DEATH:
NEVER CLOSE TOOL WITH ANY PART OF HAND OVER MUZZLE END.
OPERATORS AND BYSTANDERS MUST WEAR EYE AND HEARING PROTECTION.
ALWAYS ASSUME TOOL IS LOADED. DO NOT PLACE A FINGER ON THE TRIGGER OF LOADED TOOL UNTIL
MUZZLE END IS AGAINST WORK SURFACE AND YOU ARE READY TO MAKE A FASTENING. NEVER PLACE
YOUR HAND OVER THE MUZZLE WITH A POWDER LOAD IN THE TOOL. IF THE TOOL ACCIDENTALLY
DISCHARGES THE PISTON OR FASTENER MAY PENETRATE YOUR HAND RESULTING IN SERIOUS INJURY.
TOOL OPERATOR MUST READ AND UNDERSTAND THE ENTIRE TOOL MANUAL AND MUST COMPLETE
THE OPERATOR’S EXAM ON THE LAST PAGE. THE TOOL WARRANTY WILL NOT BE VALID UNTIL THE
TEST IS RECEIVED, WITH A COPY OF YOUR RECEIPT, AND REVIEWED BY DEWALT, INC.
WARRANTY
ALL WARRANTIES OF THE PRODUCTS DESCRIBED HEREIN, EXPRESSED OR IMPLIED, INCLUDING THE
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR PARTICULAR PURPOSES ARE SPECIFICALLY
EXCLUDED, EXCEPT FOR THE FOLLOWING: DEWALT WILL REPAIR OR REPLACE AT ITS SOLE OPTION ANY
TOOL PART, OR FASTENER WHICH WITHIN FIVE YEARS AFTER SALE BY DEWALT OR ITS DISTRIBUTORS,
IS FOUND BY DEWALT TO BE DEFECTIVE IN MATERIAL OR WORKMANSHIP, NORMAL WEAR AND TEAR
EXCLUDED.
THIS IS THE SOLE WARRANTY OF DEWALT AND THE SOLE REMEDY AVAILABLE TO DISTRIBUTOR
OR BUYER.
P3500
OPERATING
INSTRUCTIONS
90˚
DO NOT OPERATE THE P3500 TOOL UNTIL YOU HAVE READ THIS MANUAL AND RECEIVED THE PROPER TRAINING
ACCORDING TO ANSI STANDARD A 10.3.
Low velocity powder actuated fastening tool
WARNING
ESPAÑOL PG.17 | FRANÇAIS PG.33
N579217
To Next Page
Need help?
General
