Adhesive patch
Issue
The adhesive patch is peeling off your body.
Solution
Follow the insertion instructions carefully. Extra care may help you keep your sensor on for the
entire sensor session.
Site preparation
l
Site: Sensor site should be flat, clean, and completely dry before you insert the sensor.
There should be some fat under the skin at the sensor site.
l
Extra adhesive: Put on additional adhesive over the patch before applying the overpatch.
Let dry. For more recommendations, go to dexcom.com/faqs
l
Placement: The patch stays on best when it isn't where your skin folds when you bend or
near waistbands that could rub against it.
9 • Troubleshooting | Dexcom G7 Using Your Receiver 87
To Next Page
Loading...
