8514-279-001 REV B PAGE 2
TABLE OF CONTENTS
Page No.
Warnings about use and operation 2
Dryer Specifications 3
Dryer Dimensions 4-6
Uncrating 7
Dryer Exhaust 9
Dryer Shutdown 11
Dryer Controller Interface 12
Dryer Controller Factory Default Program Setting 13
Dryer Fault Codes 13
Touch Pad Description 14
Operating Instructions 16
Temporary Dryer Controller Programming 17
Permanent Dryer Controller Programming 20
Servicing and Troubleshooting 23
Preventative Maintenance Instructions 24
WARNINGS ABOUT USE AND OPERATION
It is ABSOLUTELY ESSENTIAL that the dryer be grounded to a known earth (zero) ground. This is not only
for personal safety, but is necessary for proper operation.
DO NOT MODIFY THIS APPLIANCE. KEEP SHIELDS, GUARDS, AND COVERS IN PLACE. These
safety devices are provided to protect everyone from injury.
THIS DRYER IS EQUIPPED WITH AN OVER-TEMPERATURE THERMOSTAT located to the right of the
motor on the rear of the cabinet. If the dryer cease to operate, refer to your “Service Procedure and Parts Data”
book for instructions.
CHECK THIS THERMOSTAT WHEN INSTALLING THE DRYER to assure it is not tripped. Impacts such as
rough handling in shipment, may trip the thermostat.
DO NOT SPRAY AEROSOLS IN THE VICINITY OF THIS APPLIANCE while in operation.
THIS APPLIANCE SHALL NOT BE USED TO DRY OFF CLOTHES CONTAINING SOLVENTS OR DRY
CLEANING FLUIDS.
To Next Page
Loading...
