26
OPERATING INSTRUCTIONS
STARTING THE DRYER
1) Turn on power to the dryer.
2) Load the laundry.
Place laundry in tumbler and close the door securely. Be sure laundry
does not get caught between the door gasket and front panel
when closing the door. Maximum load is the dry weight capacity listed
in the specication sheet. Do not exceed the listed capacity weight.
3) Select dry cycle.
Select the appropriate cycle for the type of load being washed. Use the
“UP” and “DOWN” keys to change the cycle on the display to the desired
cycle and press the enter button to select.
4) Start dry cycle.
Press enter to start the cycle. The display will show cycle information
throughout the cycle.
5) Pause dry cycle / End dry cycle
Press the red pause button to pause the cycle. Select Start to restart
the cycle or select Cancel Cycle to end the dry cycle.
END OF CYCLE
A tone will sound (if programmed) and the display will indicate that the cycle has
ended. Immediately remove contents of dryer. Leave the door open when the
machine is not in use.
PROGRAMMING / MANAGEMENT VIEW
ENTER PROGRAMMING MODE
1. In the cycle selection screen, scroll to Management View at the beginning
of the cycle list and select enter.
2. Enter Passcode and conrm by pressing enter.
3. Select desired option.
EDIT CYCLES
Cycles may be edited in the Edit Cycles selection. Within Edit Cycles, cycles may be
edited, copied, reordered or deleted. After making edits, select Back/Exit until out of the
option. Conrm changes when prompted to do so. When nished, select Back/Exit until
you have returned to the cycle selection screen.
Part # 8533-112-001 7/21
To Next Page
Loading...
Need help?
General
