27
AUTODRY CYCLES
Autodry cycles will dry the load to the programmed percent remaining moisture. Avail-
able moisture selections are: 25%, 20%, 15%, 10%, 7%, 5%, 3%, 1% and 0%. These
can be changed by editing cycles within the Management View. When the desired mois-
ture remaining target has been met, the dryer will advance to the next drying stage.
The drying temperature for an Autodry cycle is determined by the programmed selection
for Material.
• Cotton 190 degrees F
• Blend 160 degrees F
• Synthetic 140 degrees F
• Wool 140 degrees F
• Delicate 120 degrees F
• Ultra-delicate no heat
NOTE: Autodry cycles will perform best with loads of the same material. Performance
will vary with mixed-material loads.
OVERHEAT SENSING
All O-Series dryers are equipped with an Overheat Sensing System that will detect ab-
normally rising temperatures. If rising temperatures are detected, the control screen will
display OVERHEAT TEMPERATURE DETECTED and an alarm will sound. If the loading
door is closed, dryer models with reversing tumblers will begin tumbling after 5 seconds.
A 24 VAC output signal will also be sent to the auxiliary terminal block in the control box
on the rear of the dryer. This signal is available for customers to use with a supplemen-
tary system of their choice. For dryer models with the optional water-based re suppres-
sion system, water will also intermittently be sprayed into the tumbler. If the Overheat
Sensing System has been activated, the dryer should be inspected safely and appropri-
ately. After inspecting the dryer, it may be returned to service by resetting the controller
by pressing the RESET button on the main control board.
Part # 8533-112-001 7/21
To Next Page
Loading...
Need help?
General
