57
Door Switch Removal & Installation
Step 1: Remove front panel (see front panel removal).
Step 2: Next disconnect door switch wires from back of loading door switch. Remove door switch
by depressing the two tabs on switch and remove from the front of the panel.
Note: For the 80lb, you will have to remove the door switch cover rst by removing the two 3/8”
nuts.
Step 3: reassemble in reverse order.
Door Switch Operation & Testing
The normally open door switch must be closed (0 ohms resistance) for the motor and heat circuits
to operate. When the door is opened, the door switch opens the 24 volt control circuit.
Release
Release
Part # 8533-088-001 7/21
To Next Page
Loading...
