30
Symptom
Erratic display
Manual overtemp
Tripping Frequently
Probable Cause
Initial
Start-up
Grounding
Program
Voltage spike
Recirculating chamber
Lint Accummulation
Exhaust ducting
Excessive
lint buildup
Suggested Remedy
If erratic on initial start-up, leave power on for
approximately one hour and check machine
operation again.
Machine must be grounded by separate
conductor
back
to neutral bar in breaker box.
Check program and make corrections if
necessary.
Power down machine for
20
seconds and
repower.
If no improvement, replace control.
Remove manual overtemp thermostat and inspect
in
chamber
for
excessive lint build up . Access
also gained to
th
is chamber by removing
recirculation duct mounted at bottom of chamber.
Remove exhaust duct at rear of dryer and inspect
for
excessive lint build up in complete duct from
dryer to where duct exits building.
To Next Page