Use of the equipment in a residential area is likely to cause
radio frequency interference, in such case the user may be
required to take corrective action.
Possible solutions cannot be proposed here as the situa-
-
gins. In the cases mentioned above, it will be advisable
to carry out a careful analysis of the risks presented by
the environment in which the welding machine is operated
be evaluated from time to time. The manufacturer declines
all responsibility for damages caused by the use of the wel-
above and by any other improper use.
STATIC ELECTRICITY CAN DAMAGE PARTS OR COM-
PONENTS OF THE ELECTRONIC CIRCUITS
Use antistatic bags or boxes to store, move or transport
electronic cards. Use the machine in environments with
a temperature between +5°C e +40°C. Don’t connect the
welding machine to the Government electricity.
Repair or maintenance operations of the machine must be
The service and repair must be carried out exclusively by
-
sumable parts. This will guarantee the machine’s safety.
Unauthorized repairs carried out on this machine by unqua-
parts that are not original, can be dangerous for techni-
cians and operators and will invalidate the manufacturer’s
guarantee. For your safety follow the safety notes and pre-
cautions reported in this user manual. The manufacturer
is not liable for accidents to people or things caused by
inobservance of safety rules, improper or absurd use of the
in the maintenance paragraph.
This marking shown on the product and its literature in-
dicates that this kind of product mustn’t be disposed with
household wastes at the end of its working life in order to
prevent possible harm to the environment or human health.
Therefore the customer is invited to supply to the correct
-
fusals and recycle it in responsible way, in order to re-use
its components. The customer is therefore invited to con-
of product.
The welding machine complies with the electromagnetic compatibility test,
however there is the possibility that during the welding operation interference
may be produced on systems and/or equipment operating nearby. The electric
arc developed in its normal operation is a source of emission of electroma-
good practice for the operator to take this into account so that any precautions
and provisions are taken when he is found to operate in installations or envi-
ronments where electromagnetic disturbances cause damage to people and
things (hospitals, laboratories, people assisted by electromedical equipment;
remote transmission systems, data processing centres, apparatus and instru-
ments inserted directly or indirectly in industrial processes, etc.). As for the
provisions and precautions, possible solutions cannot be proposed here since
cases mentioned above, it will be advisable to carry out a careful analysis of the
risks presented by the environment in which the welding machine is operated
manufacturer declines all responsibility for damage caused by the use of the
any other improper use.
used allows materials recycling and their continuous use.
The re-use of recycled materials promotes environment
protection preventing pollution and reduces raw materials
requirements.
CORRECT DISPOSAL OF THE PRODUCT
ELECTROMAGNETIC COMPATIBILITY AND RELEVANT
PROBLEMS
To Next Page
Loading...