1. Firstly, switch on the remote and then LED on the remote will become
red and start flashing. Secondly, switch on the drone and place the
drone standing on the floor, the code transmitted from the remote will be
successfully paired by the receiver from the drone once the remote
sounded "di,di" twice. )
3. When both of the front and the back indicator leds stop flashing and
stay stable, then the drone is successfully matched GPS signal and
ready to fly.
Outdoor flight GPS mode
2. Push the left joystick on the remote control to the top for two seconds,
then pull the left joystick to the bottom for two seconds.
(At this time, the remote control indicator light turns to green color and
flashes slowly.) Release the left joystick, when the front and rear lights
of the drone flash quickly at the same time, the frequency pairing is
successful.
power swith
4. When the end user firstly fly this drone, he or she will need to
recalibrate the geomagnetism before reflying if the drone can not fly
stably after many crashes or changing engines.
5.How to Calibrate magnetic compass:
(1).Press and hold the normal mode button, the red lights on the rear of
the drone will be off, and the front green lights will flash quickly to enter
the calibration. The normal mode button can be released at this time.
6 7
Pairing your drone to the controller
Don't fly the drone in rainy, foggy, snowy, windy
(wind speed above 4 meters) days!
To Next Page
Loading...
Need help?
General
