5.Normal Mode Button
GPS mode /Surround flight:
During the flying, the end users can enjoy the surround flight mode by
pressing the GPS mode button for 2 to 3 seconds until the remote
beeps "di, di" twice. During surround flying, the drone will fly in the 15
meters radius semicircle range.
6.Speed-select button
5
7
6
8
4.Pairing drone:
Press and hold the button , at the same time, turn on the remote
control power switch and then release the two buttons (the remote
control indicator light flashes quickly).Press and hold the drone power
switch for three seconds, wait for the front and rear lights of the drone
to flash slowly and then release the power switch button.Push the left
joystick on the remote control to the top for two seconds, then pull the
left joystick to the bottom for two seconds.
(At this time, the remote control indicator light turns to green color and
flashes slowly.) Release the left joystick, when the front and rear lights
of the drone flash quickly at the same time, the frequency pairing is
successful.
Press the Normal Mode Button, the drone will fly in the normal mode,
no GPS function
7.GPS mode
After the drone is paired sucessfully and started to fly, press the GPS
mode button, the drone will fly in the GPS mode.
Two speeds for the drone, fast and slow.
When the drone is flying in the GPS mode, press the return button for
2 to 3 seconds, the drone will return to the position where GPS mode
started.
8.Auto return home
14
15
During the surround flight, the
consumer can adjust the flying
radius of the drone by pushing the
direction joystick up or down, and
the speed of the drone can be
adjusted by pushing the direction
joystick to the left or right.
To Next Page
Loading...
Need help?
General
