DFI CH960-CM246 - Advanced

www.dfi .com
32
Chapter 3 BIOS Setup www.dfi .comChapter 4 BIOS Setup
32
Chapter 4
System ACPI Parameters.
Aptio Setup Utility - Copyright (C) 2019 American Megatrends, Inc.
Version 2.20.1271. Copyright (C) 2019 American Megatrends, Inc.

RC ACPI Settings

CPU Confi guration

Power & Performance

PCH-FW Confi guration

Trusted Computing

PTN3460 Confi guration

WatchDog Confi guration

IT8528 Super IO Confi guration

Serial Port Console Redirection

USB Confi guration

Network Stack Confi guration

CSM Confi guration

PC Health Status
Save & ExitChipset Security Boot
Main
Advanced
 Select Screen
 Select Item
Enter: Select
+/
- :
Change Opt.
F1: General Help
F2: Previous Values
F9: Optimized Defaults
F10: Save & Exit
ESC: Exit
Advanced
The Advanced menu allows you to configure your system for basic operation. Some entries are
defaults required by the system board, while others, if enabled, will improve the performance
of your system or let you set some features according to your preference.
Important:
Setting incorrect field values may cause the system to malfunction.
RC ACPI Settings
This section is used to configure the system ACPI parameters.
Enable or disable Sys-
tem wake on alarm
event. When enabled,
System will wake on the
hr::min::sec specifi ed
Aptio Setup Utility - Copyright (C) 2019 American Megatrends, Inc.
Version 2.20.1271. Copyright (C) 2019 American Megatrends, Inc.
RC ACPI Settings
Wake system from S5
Advanced
[Disabled]
Wake system from S5
When Enabled, the system uses the RTC to generate a wakeup event.
 Select Screen
 Select Item
Enter: Select
+/
- :
Change Opt.
F1: General Help
F2: Previous Values
F9: Optimized Defaults
F10: Save & Exit
ESC: Exit