2.
Mill the denture resin.
A
Remove the adapter cap.
Use a torque screwdriver to loosen the adapter's cap screws by turning them approximately four times each, and then re-
move the adapter cap.
B
Attach the adapter base to the FX.
Align the edge of the adapter (A) with the edge of the FX (B).
C
Attach the adapter cap.
D
Tighten the cap screws (in four locations).
Tighten the screws until the torque screwdriver clicks.
Important
To x the part in place evenly, tighten the cap screws in order across the diagonals.
E
Mill the denture.
Attach the FX to the machine, and then use the CAM data to mill the denture resin together with the FX.
Usage Method
6
To Next Page
Loading...
