DGSHAPE CA-DK2 - Complete Denture (Full Denture) Cutting Method

Complete Denture (Full Denture) Cutting Method
Cut the tooth mold (the female mold for the articial teeth), arrange the articial teeth, polymerize the resin, and then cut the
complete denture (full denture).
1.
A󱐰x the CA-DK2-FX and the CA-DK2-TR.
A
Apply acrylic resin adhesive to the CA-DK2-FX (hereinafter referred to as the FX) .
Measure approximately 0.5 ml of acrylic adhesive with an eye dropper, and then drip this adhesive onto the three locations
indicated in the gure so each location has adhesive with a diameter of approximately 5 mm.
Important
• To prevent tray deformation, do not apply too much adhesive.
• The surface on which adhesive is applied will have small air bubbles, but this is not a problem during milling.
B
Attach the CA-DK2-TR (hereinafter referred to as the TR) by aligning its recessed parts with the protrusions on the
FX.
2.
Drill holes in the FX and mill the tooth molds into the TR.
A
Remove the adapter cap.
Use a torque screwdriver to loosen the adapter's cap screws by turning them approximately four times each, and then re-
move the adapter cap.
B
Attach the adapter base to the FX.
Align the edge of the adapter (A) with the edge of the FX (B).
Usage Method
17