DGSHAPE CA-DK2 - Usage Method

This section explains how to create dentures with this kit. Room-temperature polymerizing resin or heated polymerizing resin
may be used.
There are two methods for creating dentures: the denture base cutting method in which the resin is polymerized before the
denture base is cut and the articial teeth are a󱐰xed and the complete denture (full denture) cutting method in which the
mold for the articial teeth is cut and arranged and the resin is polymerized before the complete denture (full denture) is cut.
The work procedure varies depending on the resin and method used.
Room-temperature polymerizing resin
•
Denture Base Cutting Method (P. 5)
1. Create the denture
resin. (P. 5)
2. Mill the denture
resin. (P. 6)
3. A󱐰x the articial
teeth. (P. 7)
•
Complete Denture (Full Denture) Cutting Method (P. 8)
1. A󱐰x the CA-DK2-
FX and the CA-DK2-TR.
(P. 8)
2. Cut the tooth mold
(the female mold for
the articial teeth) into
the TR. (P. 8)
3. Arrange the arti-
cial teeth on the TR.
(P. 9)
4. Create the denture
resin. (P. 10)
5. Mill the denture
resin. (P. 11)
Heated polymerizing resin
•
Denture Base Cutting Method (P. 12)
1. Drill a hole in the CA-
DK2-FX. (P. 12)
2. Create the denture
resin. (P. 13)
3. Mill the denture
resin. (P. 15)
4. A󱐰x the articial
teeth. (P. 16)
•
Complete Denture (Full Denture) Cutting Method (P. 17)
1. A󱐰x the CA-DK2-
FX and the CA-DK2-TR.
(P. 17)
2. Drill holes in the
FX and mill the tooth
molds into the TR.
(P. 17)
3. Arrange the arti-
cial teeth on the TR.
(P. 18)
4. Create the denture
resin. (P. 19)
5. Mill the denture
resin. (P. 21)
Usage Method
4