DGSHAPE CA-DK2 - Heated Polymerizing Resin; Denture Base Cutting Method

Heated Polymerizing Resin
Denture Base Cutting Method
In this method, polymerize the resin, and then cut the denture base and a󱐰x the articial teeth.
1.
Drill a hole in the CA-DK2-FX.
A
Remove the adapter cap.
Use a torque screwdriver to loosen the adapter's cap screws by turning them approximately four times each, and then re-
move the adapter cap.
B
Attach the adapter base to the CA-DK2-FX (hereinafter referred to as the FX).
Align the edge of the adapter (A) with the edge of the FX (B).
B
A
C
Attach the adapter cap.
D
Tighten the cap screws (in four locations).
Tighten the screws until the torque screwdriver clicks.
Important
To x the part in place evenly, tighten the cap screws in order across the diagonals.
Usage Method
12