E
Drill a hole in the FX.
Attach the FX to the machine and cut o the part indicated in the gure.
2.
Create the denture resin.
A
Insert into the lidded container all the measured heated polymerizing resin liquid.
B
Insert 80% of the measured heated polymerizing resin powder so it ts below the liquid surface.
C
Insert the remaining 20% of the powder to cover the liquid surface.
D
Close the lid and mix the components together.
E
Wait 2 to 3 minutes until the mixture becomes porridge-like. If the room temperature is low, you may have to wait
a little longer.
Usage Method
13
To Next Page
Loading...
