F
Fix the FX onto the protrusion in the silicone stand.
Align the hole drilled in step 1. with the protrusion on the silicone stand.
Supplemental
Applying vegetable oil to the protrusion on the silicone stand makes it easier to remove the resin after polymerization.
G
Pour the mixture into the FX.
Flatten the surface of the mixture with a spatula.
H
Cover the mixture with a piece of tissue paper.
I
Place a polyethylene sheet on the tissue paper.
J
Lightly press down on the polyethylene sheet and the tissue paper to absorb the liquid layer from the surface of
the mixture.
Important
A liquid layer remaining on the surface may cause air bubbles to form there after polymerization.
K
Remove the polyethylene sheet and the tissue paper.
L
Place the silicone stand and the FX in the pressure pot.
Usage Method
14
To Next Page
Loading...
