DGSHAPE CA-DK2 - Complete Denture (Full Denture) Cutting Method

Complete Denture (Full Denture) Cutting Method
Cut the tooth mold (the female mold for the articial teeth), arrange the articial teeth, polymerize the resin, and then cut the
complete denture (full denture).
1.
A󱐰x the CA-DK2-FX and the CA-DK2-TR.
A
Apply acrylic resin adhesive to the CA-DK2-FX (hereinafter referred to as the FX).
Measure approximately 0.5 ml of acrylic adhesive with an eye dropper, and then drip this adhesive onto the three locations
indicated in the gure so each location has adhesive with a diameter of approximately 5 mm.
Important
• To prevent tray deformation, do not apply too much adhesive.
• The surface on which adhesive is applied will have small air bubbles, but this is not a problem during milling.
B
Attach the CA-DK2-TR (hereinafter referred to as the TR) by aligning its recessed parts with the protrusions on the
FX.
2.
Cut the tooth mold (the female mold for the articial teeth) into the TR.
A
Remove the adapter cap from the adapter.
Use a torque screwdriver to loosen the adapter's cap screws by turning them approximately four times each, and then re-
move the adapter cap.
B
Attach the adapter base to the FX.
Align the edge of the adapter (A) with the edge of the FX (B).
Usage Method
8