Need help?Do you have a question about the DGSHAPE DWX-52DCi and is the answer not in the manual?
Guides on how to launch, manage, and close the VPanel software.
Introduces the VPanel interface, including the top window and key functional areas.
Explains the status lights and operation buttons on the machine's control panel.
Step-by-step instructions for powering the machine on and off.
Covers necessary CAM settings, workpieces, milling burs, cleaning tools, adapters, and air pressure.
Comprehensive guide to the steps for initiating a milling job, from workpiece mounting to data output.
Steps for aborting milling output or removing data from the standby list.
Configuration for automatic milling bur switching to ensure continuous milling.
Essential safety warnings and general care instructions for performing maintenance.
Procedures for routine cleaning of the machine's internal and external parts.
Outlines scheduled maintenance tasks like spindle run-in and collet retightening.
Addresses common operational issues like startup failures or VPanel recognition problems.
Solutions for issues affecting the surface finish and dimensions of milled parts.
Troubleshooting steps for driver, software, and VPanel installation failures.
Explains error codes and provides procedures for resolving them.
General| Category | Dental Milling Machine |
|---|---|
| Manufacturer | DGSHAPE |
| Model | DWX-52DCi |
| Number of Axes | 5 |
| Max Spindle Speed | 60, 000 RPM |
| ATC Method | Automatic Tool Changer |
| Power Supply | AC 100-240V, 50/60Hz |
| Spindle Cooling Method | Air Cooling |
| Material Compatibility | Zirconia, Wax, PMMA, Composite Resin |
| Operating Environment | Temperature: 10-35°C, Humidity: 35-80% (non-condensing) |
| Drive System | Servo motor |
| Tool Changer Capacity | 15 station automatic tool changer |
To Next Page
