DGSHAPE DWX-52DCi - An Unknown Error Occurred; A Machine that Has the same ID Has Been Connected; The Adapter to Use During Milling Has Not Been Set

Responding to Error Messages
111
Chapter 4 FAQ
B
Clean the barcode sensor.
" P.60 "Cleaning Inside the Magazine Cover"
"****-****" An unknown error occurred.
Procedure
Restart the machine.
If the Error Occurs Again
Contact your authorized DGSHAPE Corporation dealer.
A machine that has the same ID has been connected.
Procedure
A
Remove all the USB cables that are connected to the computer.
B
Delete the unnecessary devices from "Devices and Printers."
Delete the unnecessary devices according to the procedure under P.90 "Driver Installation Is Impossible".
C
Connect multiple devices.
" "Setup Guide"
The adapter to use during milling has not been set.
Procedure
A
Install the adapter to use in the adapter stocker.
B
Send the milling data again.