79
Chapter 4 FAQ
Machine Trouble
Initial Operations Are Not Performed or Fail
Is the front cover or the
magazine cover open?
Keep the front cover and the magazine cover
closed during startup. For safety, the initial
operations are not performed if a cover is
open when the machine starts.
—
Is the milling bur caught on
anything?
The milling bur attached to the spindle unit
may fail to perform the initial operations if
it is caught on the workpiece or rotary axis
unit. Try to detach the milling bur using the
emergency release function in VPanel.
P.15
Is anything caught on the
spindle unit or rotary axis unit?
Open the maintenance cover and make sure
that no workpiece or milling waste is caught
on these units.
—
The Operation Button Does Not Respond
Is the front cover or the
magazine cover open?
This machine restricts some operations when
the front cover or the magazine cover is open.
Close all of the covers.
—
Are you wearing gloves?
The operation button will not respond if you
are wearing gloves. Operate the button with a
bare hand.
—
VPanel Does Not Recognize the Machine
Is the cable connected?
Make sure that the cables are connected.
Refer to the "Setup Guide" ("Connecting the
Cable") to perform the work.
Setup
Guide
Is the driver installed correctly?
If the connection to the computer is not made
according to the procedure described, the
driver will not be installed correctly. VPanel
will not function normally if the driver is not
congured correctly. Check again to ensure
that the connection was made using the
correct procedure.
P.87
Did you verify the connection
procedure when connecting
more than one machine?
There is a possibility that the connection
procedure was performed incorrectly. Make
sure that connections were performed
correctly.
Refer to the "Setup Guide" ("Connecting
Multiple Units") to perform the work.
Setup
Guide
To Next Page
Loading...
