ATC Milling bur change test Perform tests, maintenance, and other tasks related
to operation with the ATC magazine.
" P.62 "Situations Requiring Maintenance"
" P.61 "Care and Storage of Detection Pin and
Automatic Correction Jig"
Open collet/Close collet
Emergency release This button is enabled when the power is turned
on while a cover is open. Use this function if the
initial operations cannot be performed because, for
example, the milling bur is caught on the workpiece.
Spindle Reset "Work time" displays the work time of the spindle.
After replacing the spindle unit, click [Reset] to reset
the value to 0.
Spindle run-in
" P.63 "Spindle Run-in (Warm-up)"
Spindle replacement Click this button to open the "Spindle replacement"
window.
" P.62 "Situations Requiring Part
Replacement"
Report Show Display the rmware version, the total operating
hours, and the error window.
Get Obtain a le in which the information of the various
logs is collected.
Cleaning tool Reset "Work time" displays the work time of the cleaning
tool. After replacing the cleaning tool, click [Reset]
to reset the value to 0. You can use "Replacement
time" to set the replacement time of the cleaning
tool.
VPanel Window and Functions
15
Chapter 1 Basic Operation
To Next Page
Loading...
