84
Chapter 4 FAQ
Milling Quality Problems
The Milled Surface Is Not Attractive
Is the workpiece rmly secured
in place?
Check the mounting condition of the
workpiece. If the workpiece is not mounted
on the machine correctly, the workpiece may
come loose during milling and may become
misaligned.
P.33
Is the milling bur worn?
If the same milling bur is used for milling for
a long period of time, it will become worn and
affect milling results. Try replacing the milling
bur with a new one. The work time of the
milling bur can also be managed in VPanel.
P.23
Are the milling conditions too
strict?
Strict milling conditions may affect milling
results. Review the CAM milling conditions.
—
There Is a Line of Level Difference in the Milling Results
Is the machine out of correction?
The origin point may become out of position
due to prolonged use or relocating the
machine, which can result in a line of level
difference. Perform automatic correction. If
the expected results cannot be obtained even
after performing automatic correction, perform
manual correction. With manual correction,
changing the Y value in Origin point may
improve the situation.
P.20
P.65
Are the CAM milling conditions
correct?
Depending on the milling conditions, a line of
level difference may occur. Review the CAM
milling conditions.
—
Chipping Occurs (Edges of Milling Products Become Chipped)
Is the installation base of the
machine secure?
The vibration from milling can shake the
installation base. Install the machine in a
stable location.
—
Is the workpiece rmly secured
in place?
Check the mounting condition of the
workpiece. If the workpiece is not mounted
on the machine correctly, the workpiece may
come loose during milling and may become
misaligned.
P.33
To Next Page
Loading...
