Part name Replacement time/Guideline
Collet
If the collet is deformed.
If an overload error or other error occurs, the collet may be deformed.
For information on how to perform replacement, refer to the replacement
instruction manual included with the part.
Spindle belt
If the spindle belt is worn.
For information on how to perform replacement, refer to the replacement
instruction manual included with the part.
Cleaning tool
If the brush bristles have spread out.
* The milling bur holder is not included with optional products.
" P.77 "Replacing the Cleaning Tool"
Spindle Run-in (Warm-up)
Spindle run-in (warm-up) may be required to stabilize the rotation of the spindle.
Situations Requiring This Work
• When installing the machine
• When replacing the spindle unit
• When the machine has not been used for a prolonged period
• Before use on days when the ambient temperature is low
Procedure
A
Close the front cover and turn on the power.
B
Show VPanel.
" P.7 "Displaying VPanel"
Periodic Maintenance
63
Chapter 3 Maintenance
To Next Page
Loading...
