DGSHAPE DWX-52DCi - Uninstalling Vpanel

Installation Problems
93
Chapter 4 FAQ
6. From the [Start] menu, select [All Programs], then [Accessories], then [Run], and then click [Browse].
7. Select the name of the drive or folder where the driver is located. (*)
8. Select "SETUP64.EXE" (64-bit version) or "SETUP.EXE" (32-bit version) and click [Open], and then click [OK].
9. The [User Account Control] window will appear. Click [Allow].
10. The setup program for the driver starts.
11. Click [Uninstall] to select this operation. Select the machine to remove and click [Start].
12. If it is necessary to restart your computer, a window prompting you to restart it will appear. Click [Yes].
13. The uninstallation will be nished after the computer restarts.
(*)
When using the CD-ROM, specify the folder as shown below. (This is assuming your CD-ROM drive is the D drive.)
D: \Drivers\X64 (64-bit version)
D: \Drivers\X86 (32-bit version)
If you're not using the DGSHAPE Software Package CD, go to the DGSHAPE Corporation website
(http://www.dgshape.com/) and download the driver for the machine you want to remove, and then specify the
folder where you have extracted the downloaded le.
Uninstalling VPanel
When uninstalling VPanel, perform the following procedure.
Windows 10 and 8.1
1. Exit VPanel. (Right-click in the task tray and select "Exit.")
2. Right-click the [Start] button, and then click [Control Panel]. Click [Uninstall a program] (or [Programs and
Features]).
3. Select "VPanel for DWX," and then click [Uninstall].
4. Follow the on-screen instructions to uninstall the program.
Windows 7
1. Exit VPanel. (Right-click in the task tray and select "Exit.")
2. From the [Start] menu, click [Control Panel], and then click [Uninstall a program] (or [Programs and Features]).
3. Select "VPanel for DWX," and then click [Uninstall].
4. Follow the on-screen instructions to uninstall the program.