DGSHAPE DWX-52DCi - 0000 the Milling Bur Sensor was Not Found; The % Milling Bur Cannot be Released

Responding to Error Messages
97
Chapter 4 FAQ
"101C-0000" The milling bur sensor was not found.
Situation/Error Cause
The operation may be inhibited by milling waste or an obstruction.
Procedure
A
Turn off the power.
B
Remove any objects blocking the operation of the machine and any accumulated milling
waste.
C
Turn on the power, and then resume operation.
"101D-****" The % milling bur cannot be released.
"%" indicates a milling bur stocker number from 1 to 15.
Situation/Error Cause
The returning of the milling bur failed. The inside of the collet or the ATC magazine might be dirty.
Procedure
A
Hold down the operation button on the built-in panel.
This will clear the error.
B
Click [Open collet] in VPanel.
The collet will open.
" P.14 ""Maintenance" Tab"
C
Remove the milling bur.
D
Clean the ATC magazine.
" P.59 "Cleaning after Milling Finishes"
Situation/Error Cause 2
The collet and milling bur are axed together and cannot be separated. The inside of the collet might be dirty.
Procedure
Retighten the collet.
" P.71 "Retightening the Collet"