DGSHAPE DWX-52DCi - 1000-**** the % Limit Switch was Not Found; 1006-02** the % Axis Position Has Been Shifted

Responding to Error Messages
95
Chapter 4 FAQ
"1000-****" The % limit switch was not found.
"%" indicates the axis name (X, Y, Z, A, or B or a combination of these axes).
Situation/Error Cause
The operation may be inhibited by milling waste or an obstruction.
Procedure
A
Turn off the power.
B
Remove any objects blocking the operation of the machine and any accumulated milling
waste.
C
Turn on the power, and then resume operation.
"1006-02**" The % axis position has been shifted.
"%" indicates the axis name (X, Y, Z, A, or B or a combination of these axes).
Situation/Error Cause 1
The motor position may have been lost.
Procedure
A
Remove any objects blocking the operation of the machine and any accumulated milling
waste.
B
Hold down the operation button on the built-in panel.
This will clear the error.
Situation/Error Cause 2
The milling conditions may be excessively strict.
Procedure
A
Hold down the operation button on the built-in panel.
This will clear the error.
B
Review the CAM settings and the shape specied in the CAD data.