DGSHAPE DWX-52DCi - 0001 the Changer Has Collided with the Adapter; 1030-0000 the Dust Collector Is Not Working

Responding to Error Messages
105
Chapter 4 FAQ
"102E-0001" The changer has collided with the adapter.
Procedure
A
Firmly press the adapter into the back of the adapter stocker.
Remove any pieces of cutting waste and foreign objects that have afxed to the adapter stocker.
" P.43 "Step 2: Attaching the Adapter to the Machine"
B
This will clear the error or milling will resume.
If the error occurred during milling
Press the operation button on the built-in panel.
Milling will resume.
If the error occurred while the machine was on standby
Hold down the operation button on the built-in panel.
This will clear the error.
If the Error Occurs Again
Procedure
A
Turn off the power.
B
Firmly press the adapter into the back of the adapter stocker.
Remove any pieces of cutting waste and foreign objects that have afxed to the adapter stocker.
" P.43 "Step 2: Attaching the Adapter to the Machine"
C
Turn on the power.
"1030-0000" The dust collector is not working.
Situation/Error Cause
• The dust collector connection method is not correct.
• The dust collector is not turned on.
Procedure
Turn the dust collector on, and then check the dust collector settings and the lter.