DGSHAPE DWX-52DCi - The % Milling Bur Might be Broken

Responding to Error Messages
99
Chapter 4 FAQ
"101E-****" The % milling bur might be broken.
"%" indicates a milling bur stocker number from 1 to 15.
Situation/Error Cause
• The milling bur is broken.
• The milling bur holder is out of position.
Procedure
A
Hold down the operation button on the built-in panel.
This will clear the error.
B
Check the status of the milling bur.
When the milling bur is broken
Replace the milling bur with a new one.
When the installation position of the milling bur holder is not appropriate
Install the milling bur holder in the correct position.
" P.45 "Step 3: Setting the Milling Bur"
Situation/Error Cause 2
The milling conditions may be excessively strict.
Procedure
A
Hold down the operation button on the built-in panel.
This will clear the error.
B
Review the CAM settings and the shape specied in the CAD data.
If the Error Occurs Again
The collet may have worn out and its ability to retain the milling bur may have deteriorated. Replace the collet
with a new one.
" P.62 "Situations Requiring Part Replacement"