DGSHAPE DWX-52DCi - 1017-0000 the Front Cover was Opened; 1017-0001 the Front Cover or the Magazine Cover was Opened

Responding to Error Messages
96
Chapter 4 FAQ
"1017-0000" The front cover was opened.
Situation/Error Cause
The front cover was opened during spindle rotation. For safety, the machine comes to an emergency stop if the
front cover is opened while the spindle is rotating. Do not open the front cover while the spindle is rotating. Doing
so may aect the milling results.
Procedure
To continue milling
Press the operation button on the built-in panel.
Milling will resume.
To abort milling
Hold down the operation button on the built-in panel.
"1017-0001" The front cover or the magazine cover was opened.
Situation/Error Cause
The front cover or the magazine cover was opened while the disk changer was operating. For safety, the machine
comes to an emergency stop if a cover is opened while the disk changer is operating. Do not open the covers
while the disk changer is operating.
Procedure
To continue milling
Press the operation button on the built-in panel.
Milling will resume.
To abort milling
Hold down the operation button on the built-in panel.