DGSHAPE DWX-52DCi - Adapter Ids Cannot be Read; No Data Is Being Output to the Machine, or the Machine will Not Operate Even Though Data Is Being Output

Machine Trouble
80
Chapter 4 FAQ
Was the machine ID changed?
If the machine's ID has been changed, restart
VPanel.
P.13
Adapter IDs Cannot Be Read
Is part of the barcode on the
adapter ID label missing or is
this barcode dirty?
Clean the barcode. If part of the barcode is
missing or if the barcode is excessively dirty,
afx a new label from the sheet of labels
included with the machine.
P.61
Has milling waste afxed to the
barcode sensor?
Clean the barcode sensor inside the magazine
cover, and then read the adapter ID.
P.60
No Data Is Being Output to the Machine, or the Machine Will Not Operate Even Though Data Is Being Output
Is the front cover or the
magazine cover open?
If the front cover or the magazine cover is
open, the machine will not start milling even if
milling data is being received. Close all of the
covers and press the operation button to start
milling.
—
Does VPanel recognize the
machine?
Verify that a message other than "OFFLINE"
is shown in VPanel.
—
If multiple machines are
connected, is the correct
machine selected?
Select the machine to output milling data to on
the VPanel screen.
—
Is operation paused?
Operation is paused if the PAUSE LED is lit.
When the machine is paused, milling stops
and some operations are restricted. Pressing
the operation button of the machine will cancel
the pausing of operations. Holding down the
operation button will abort milling.
P.25
Is initialization or a data cancel
in progress?
Milling data received during the initial
operations or during a data cancel will be
cancelled. Make sure to output milling data
after conrming that the machine is in the
standby status.
—
Is the milling data correct?
Check the milling data.
—
Has an error occurred?
The ERROR LED will ash if an error occurs.
A description of the error is displayed in
VPanel.
P.94