Milling Bur Replacement Time
When all the milling burs are new
The milling bur with the smaller milling bur stocker number in the combination is used rst.
Example: If Intelligent Tool Control is set to the combination of milling bur stocker 1, milling bur stocker 2, and
milling bur stocker 3, stocker 1 is used.
When at least one milling bur has been used but has not reached its replacement time
Among the milling burs that have not reached their replacement times, the milling bur with the longer work time
is given priority when determining which milling bur to use.
When all the milling burs have reached their replacement times
The milling bur with the shorter work time is given priority when determining which milling bur to use.
Purchasing Additional Adapters
Six adapters are included with this machine, and this machine can manage all six adapters at the same time.
However, you cannot remove workpieces that are being milled from their adapters because doing so will make
it impossible to manage information such as the position information in the CAM data. To use workpieces
completely, we recommend that you prepare spare adapters (up to a maximum of 26 adapters [IDs: A to Z]).
Contact your authorized DGSHAPE Corporation dealer or visit our website (http://www.dgshape.com/) to
purchase items.
Work That Is Required after Purchasing Adapters
Adapter ID labels are not axed to adapters that are purchased as optional products. Ax the adapter ID labels
included as an optional product with this machine to the additional adapters before using them.
To Perform Continuous Milling
56
Chapter 2 Milling
To Next Page
Loading...
