Milling Quality Problems
86
Chapter 4 FAQ
A Hole Opens in the Milling Results
Do the milling bur diameter and
the milling bur stocker number
match the CAM settings?
Check the CAM's milling bur settings.
—
Is the machine out of correction?
The origin point may become out of position
due to prolonged use or relocating the
machine, which can affect milling results.
Perform automatic correction. If the expected
results cannot be obtained even after
performing automatic correction, perform
manual correction. With manual correction,
changing the Z value in the + direction in
Origin point may improve the situation.
P.20
P.65
Are the milling conditions too
strict?
Strict milling conditions may affect milling
results. Review the CAM milling conditions.
—
The Dimensions of the Milling Results Do Not Match
Does the milling bur diameter
match the CAM settings? Is the
CAM shrinkage factor setting
appropriate for the workpiece?
Check the CAM settings.
—
Do the settings of the sintering
program match the workpiece?
Check the sintering program settings to see
if they match the manufacturer’s workpiece
being used.
—
To Next Page
Loading...