28
Chapter 2 Milling
Preparing for Milling ....................................................................................................................... 29
CAM Settings Necessary for Milling ............................................................................... 29
Workpiece ...............................................................................................................................29
Milling bur ............................................................................................................................... 30
Cleaning tool ..........................................................................................................................30
Adapter/Adapter ID ............................................................................................................. 31
Compressed Air (Setting the Regulator) ...................................................................... 32
Starting Milling .................................................................................................................................. 33
Step 1: Mounting the Workpiece on the Adapter .....................................................33
Step 2: Attaching the Adapter to the Machine .......................................................... 43
Step 3: Setting the Milling Bur ......................................................................................... 45
Step 4: Setting the Cleaning Tool ................................................................................... 47
Step 5: Checking the Regulator Setting ....................................................................... 49
Step 6: Outputting Milling Data and Starting Milling ............................................. 50
Step 7: Removing the Adapter Cap from the Machine ...........................................53
Pausing or Canceling Milling ........................................................................................................ 54
Aborting Output ................................................................................................................... 54
Removing Milling Data in Standby from the Output List ...................................... 54
To Perform Continuous Milling ................................................................................................... 55
Automatically Switching Out the Worn Milling Bur
(Intelligent Tool Control) .................................................................................................... 55
Purchasing Additional Adapters ..................................................................................... 56
Chapter 2 Milling
To Next Page
Loading...
