Starting Milling
Step 1: Mounting the Workpiece on the Adapter
The mounting method diers depending on the workpiece type and size.
" P.33 "For Disk Workpieces"
" P.37 "For Pin-type Workpieces"
You can mount workpieces on any of the adapters without any problems, but you have to specify the ID of the
used adapter in CAM.
Adapter ID
Point
When using multiple adapters, use the included
adapter rack.
For Disk Workpieces
Required Items
adapter Disk workpiece Torque screwdriver
33
Chapter 2 Milling
To Next Page
Loading...
