Cleaning the Milling Bur/Adapter
Use the included cloth for care to wipe o any dirt from the portion indicated in the gure.
Care and Storage of Detection Pin and Automatic Correction Jig
For automatic correction, use the detection pin and the automatic correction jig. The presence of rust, scratches,
or grime on the detection pin or the automatic correction jig makes accurate detection impossible, which in turn
may make it impossible to perform milling as intended and may even damage the machine.
Care and Storage
• Before use, wipe these items clean using a dry clean cloth (included with the machine) and check that no dust,
rust, or scratches are present.
• Store the detection pin and the automatic correction jig in the storage compartment.
Part to be wiped
Store the automatic correction jig with the
surface shown in the above gure visible.
Also carefully wipe away
any milling waste that has
afxed to the barcode.
Daily Maintenance
61
Chapter 3 Maintenance
To Next Page
Loading...