DGSHAPE CA-DK2 - Page 12

5.
Mill the denture resin.
A
Attach the adapter base to the FX.
Align the edge of the adapter (A) with the edge of the FX (B) before attaching the base.
B
Attach the adapter cap.
C
Tighten the cap screws (in four locations).
Tighten the screws until the torque screwdriver clicks.
Important
To x the part in place evenly, tighten the cap screws in order across the diagonals.
D
Mill the complete denture (full denture).
Attach the FX to the machine, and then use the CAM data to mill the denture resin together with the FX.
E
Loosen the cap screws, and then remove the adapter cap and the adapter from the FX.
Usage Method
11