4.
Create the denture resin.
A
Mix the room-temperature polymerizing resin powder and the liquid together well.
After mixing, use a vibrator to extract the air bubbles.
B
Pour the mixture into the FX where the articial teeth have been set.
C
Wait for the surface of the mixture to dry.
D
Place the FX in the pressure pot.
E
Check the pressure pot's water level.
Adjust the amount of water if it is not at the level indicated on the pressure pot.
F
Set the pressure, temperature, and time on the pressure pot to polymerize the resin.
Set the values that are required in order for the room-temperature polymerizing resin being used to polymerize.
G
After polymerization, cool the resin at room temperature.
Usage Method
10
To Next Page
Loading...
