DGSHAPE CA-DK2 - Page 19

C
Attach the adapter cap.
D
Tighten the cap screws (in four locations).
Tighten the screws until the torque screwdriver clicks.
Important
To x the part in place evenly, tighten the cap screws in order across the diagonals.
E
Drill holes in the FX and mill the tooth molds into the TR.
Attach the FX and TR to the machine, and then use the CAM data to mill the tooth mold to use in tting the TR with arti-
cial teeth. Also drill holes in the FX.
F
Remove the FX and TR from the machine, loosen the cap screws, and then remove the adapter cap and the adapter
from the FX.
3.
Arrange the articial teeth on the TR.
A
Apply one to two drops of acrylic resin adhesive to the TR's tooth mold.
B
Check the shape of the tooth mold and the orientation of the articial teeth.
C
Push the articial teeth onto the TR's tooth mold.
D
Check that the articial teeth have been attached to the tooth mold without any gaps.
Important
The articial teeth have an orientation that matches the
tooth mold
. Attach teeth with the proper orientation.
Usage Method
18