5 IDENTIFICATION
Every DHOLLANDIA tail lift is identified by and labelled with a
unique 8-digit serial number (with or without a space between
the first and last 4 digits). Use this number for any inquiry on a
particular tail lift, or when ordering replacement parts.
In addition to the tail lift type and serial number, the various serial
number labels provide additional information, such as: the
maximum rated lift capacity and load chart, the bumper
certification number, the date of manufacture, etc...
These labels are usually affixed to the body various tail lift
components, and can be found in following locations (the yellow
arrows point to the serial numbers):
On the main external control box
6 DESCRIPTION AND TAIL LIFT TERMINOLOGY
6.1 GENERAL
DHOLLANDIA tail lifts are developed and manufactured using state-of-the-art technology, high quality materials and components,
and highly skilled workmanship. They comply with the European CE safety regulations mentioned in the Declaration of Conformity
issued with each lift (unless agreed otherwise for tail lifts exported outside of CE region).
The manual distinguishes between :
1. Column lifts that stop at the vehicle floor [see 6.1.1 below]
2. Columns lifts that travel above the vehicle floor [see 6.1.2 below]
The product names DH-VO* and DH-VH* stand for generic, general purpose lifts. If complemented by a G, the tail lifts DH-VOG*
and DH-VHG* refer to special executions adapted to the distribution of gas bottles.
In its travel position, the platform of the column tail lift is stowed vertically behind the vehicle body. Before use, the platform is
lowered approx. 15 cm, then tilted open 90 degrees from the vertical travel position to a horizontal work position.
Affixed to the side of the vehicle body, or on the platform
To Next Page
Loading...
Need help?
General
